TM 11-6625-444-14-2
Section III. PREPARATION FOR MOVEMENT
3-14. General
desired location.
This section contains information regarding
movement of the voltmeter. Rack removal is
d e s c r i b e d first, followed by i n s t r u c t i o n s for
bench or shelf movement.
a. Set the POWER OFF/ON switch to OFF by
releasing it to the out position.
b. Disconnect any test leads or cables from
the front and rear panel terminals, if necessary.
a. Set the POWER OFF/ON switch to OFF by
releasing it to the out position.
c. Remove the voltmeter from the equipment
r a c k by removing the front mounting screws
b. Disconnect any test leads or cables from
from the brackets. (See figure 2-4.)
the front and rear panel terminals, if necessary.
