TM 55-4920-244-14
(5) Install spring (20), screw (21),
4-51. Handle Assembly.
and locknut (22) in proper position on bottom
a. Reassembly. Reassembly is accom-
lip of compartment.
plished by installation.
(6) Install fastener (17), grommet
b. Installation. Install handle assembly
(19), and snap ring (18) on door (16). Align
hinge half on door properly with hinge half
on base assembly (31) and install hinge pin
4-52. Base Assembly (Figure 3-1).
(15).
a. Reassembly.
b. Installation.
(1) Install wheel mounts (28) and
(1) Install cable and printed circuit
secure with screws (29) and locknuts (30).
board assembly, part No. BH1766 (para.
(2) Install wheels (26) on axle of
(2) Install voltage regulator (para.
wheel mounts (28) and secure with retaining
rings (27).
(3) Install handle assembly (para.
(3) Install support post (23) and se-
cure with screws (24) and locknuts (25).
(4) Install probe storage compart-
(4) Set base assembly (31) in an up-
ment (para.
right position.
4-37
