TM 11-6625-539-15-2
GENERAL SUPPORT TESTING PROCEDURES
8-2. Test Equipment and Material
8-1. General
The only test equipment and material required for
a. Testing procedures are prepared for use by
testing the T.S-1836B/U is Voltmeter, Electronic
Electronic Field Maintenance Shops and Electronic
ME-30(*)/U and a 100-ohm, 1 percent, -watt.
Service Organizations responsible for general sup-
resistor.
port maintenance of electronic equipment to deter-
mine the acceptability of repaired equipment. These
8-3. Modification Work Orders
procedures set forth specific requirements that re-
The performance standards listed in the teats (paras
paired equipment must meet before it is returned to
8-5 and 8-6) are based on the assumption that all
the using organization.
modification work orders have been performed. DA
b. Comply with the instructions preceding each
Pam 310-7 lists current MWO's.
chart before proceeding to the chart. Perform each
step in sequence. Do riot vary the Sequence. For each
step, perform all the actions required in the Control
a. Test Equipment and Materials. None required.
settings columns; then perform each specific test pro-
b. Test Connection and Conditions.
cedure, and verify it against its performance
(1) No connections are necessary.
standard.
(2) Remove the test set chassis from its case.
c. Procedure.
-
.
.
--
None--------------- Controls may be in
1
a. Inspect case and chassis for
a. No darnage evident or park
missing. External surfaces in-
any position.
damage, missing parts, and
tended to be painted do not
defective condition of paint.
show bare metal.
painting recommended In
of refinishing whenever
binding pints,
and
will not be
or polished
with
b. Inspect afl controls and mechan-
b. Screws, bolts, and nuta will be
ical assemblies for loose or
tight with none missing.
missing screws, bolts, and nuts.
c. No loosee parts or damage. No
c. Inspect all connectors, sockets,
missing parts.
receptacles, and fuseholders
and meter for looseness,
damage, or missing parts.
2 None---------------
a. Controls rotate. freely without
Controls may be in
a. Rotate all panel controls
binding or excessive looseness.
any position.
throughout their limits of travel.
b. Stops operate properly without
b. Inspect dial stops for damage or
evidence of damage.
bending; check for proper
operation.
c. Switches operate properly.
c. Operate switches-------------
MX-1292/PAQ
3 Connect mercury
Controls may be in
Turn on mercury vapor lamp and
All repaired or disturbed electrical
vapor lamp.
any position.
components and chassis surfaces
expose portion of equipment that
are covered. There must be no
haa been repaired or disturbed to
varnish on switch contacts or
direot rays of lamp.
moving parta of mechanical
assemblies.
of
