TM 11-6625-291-14/TO 33A1-7-23-1
TROUBLESHOOTING (CONT)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
2. Meter needle does not return to zero after equipment is turned off.
Check for bad meter.
Refer to a higher level of maintenance.
3. Meter needle does not show any reading when equipment under test is turned on.
Check for bad output meter.
Refer to a higher level of maintenance.
4. Impedance control knob does not point needle to far right of scale for any setting.
Check for bad control knob.
Refer to a higher level of maintenance.
5. Meter multiplier knob does not point needle near center of scale for any setting.
Check for bad control knob.
Refer to a higher level of maintenance.
4-9
