TM 11-6625-539-144
ORGANIZATIONAL MAINTENANCE
Section I. ORGANIZATIONAL TOOLS AND EQUIPMENT
4-1. Special Tools and Test Equipment
42. Repair Parts
No special tools or test equipment are required for
Refer to TM 11-6625-539-24P for repair parts
organizational maintenance of the test set.
available for use at organizational maintenance.
REPAINTING AND REFINISHING INSTRUCTIONS
Section Il.
careful not to erase panel markings. No painting
is required on the back of the panel or anywhere
The case and cover of this equipment are con-
in the interior of the test set.
structed of molded plastic. The color is the same
throughout the full thickness of the parts. For
b. Refer to TB 74610 for instructions on the
this reason, no repainting of these parts is re-
care of painting equipment.
quired. Touchup painting should be done only on
those parts the original surface of which had been
45. Refinishing Exterior Surfaces
painted.
You may remove gouges or scratches in the plas-
tic case or cover with fine sandpaper. Sand only
4-4. Repainting Instructions
enough to remove rough edges. Do not disrupt the
surrounding finish any more than necessary. Do
a. Touch up the face of the front panel using
light spray enamel per spec MIL-E-1590B. Be
not attempt to fill scratches or gouges with paint.
Section Ill.
LUBRICATION INSTRUCTIONS
4-6. Lubrication Instructions
No lubrication is required for the test set.
Section IV. ORGANIZATIONAL PREVENTIVE MAINTENANCE CHECKS AND SERVICES
ties together with corrective action as prescribed
in TM 38750.
To insure that the test set is always ready for
operation, inspect it systematically so that defects
may be discovered and corrected before they re-
48. Organizational Preventive Maintenance
suit in serious damage or failure. The necessary
Checks and Services
preventive maintenance checks and services are
Preventive maintenance checks and services ap-
plicable to organizational maintenance are listed
item numbers indicate the sequence of and the
minimum inspection required. Record all deficien-