TM 11-6625-539-14-4
CAUTION
nect the test leads from the remote test jacks.
Fold them so that they fit into the equipment
Remove batteries before shipment or in-
cover. Position the cover on the test set and
active storage of 30 days or more.
secure the four latches.
Section IV. OPERATION UNDER UNUSUAL CONDITIONS
2-20. Operation Under Various Moisture or
2-18. General
Humidity Conditions
This test set is normally used in an electronics
a. During on-location testing of equipment, pro-
repair shop and is not usually subjected to ex-
tect the test set from direct contact with rain or
treme climatic or other environmental conditions.
other moisture. Heavy collections of moisture on
In general, give it the same environmental protec-
the front panel test jacks could affect meter indi-
tion that is required for the equipment it is being
cations during testing of semiconductor devices.
used to test.
b. Take particular care to prevent the unit from
2-19. Operation Under Extreme Temperture
being splashed with or dropped into salt water.
Conditions
Salt water is a good conductor of electricity and
Temperature conditions in which this test set can
could adversely affect test outputs.
normally be operated (32 to 122F (0 to 50C
max)) will not have any marked effect upon its
c. Whenever possible while the unit is exposed
operation or its accuracy. You should not subject
to moisture or conditions of high humidity, keep
the unit to higher or lower temperature than
the cover on the case to seal out any moisture.
absolutely required.
Open the case only while the unit is being used.
