TM 11-6625-444-14-2
OPERATING INSTRUCTIONS
Section I. CONTROLS AND INSTRUMENTS
plied to the HI and LO terminals on any voltage
3-1. General
range. Potentials of 200 V peak may be applied
between the LO and GUARD terminals. Poten-
This section fully describes the controls and in-
tials of 300 V peak may be applied from GUARD
struments of the AN/GSM-64C Voltmeter. Figure
to case.
3 - 1 shows the location of each front panel
control and instrument while figure 3-2 shows
t h e location of the rear panel controls and
instruments Table 3-1 describes the function of
each front panel control and instrument while
CAUTION
control and instrument.
Do not exceed the maximum poten-
tials between terminals that are
marked on the front and rear panels
or damage to the equipment may
Voltages of up to 1000 Vdc or rms may be ap-
occur.
