TM 11-6625-444-14-2
except use the two new screws supplied with
(8) Attach the other angle bracket to the
left front side of the voltmeter by securing it with
the rack mounting kit.
the new No. 8 screws supplied with the kit.
(5) Remove the two No. 8 screws located
on the right side casting near the front of the
(9) To attach the right chassis-slide assem-
bly, first unlatch and separate the inner member
voltmeter. These empty threaded holes will be
from two outer slide members.
used in step (6).
(10) Orient the inner slide member so that
(6) Mount one of the angle brackets to the
the scalloped corner faces the upper front cor-
right front side of the voltmeter by fastening it
ner of the voltmeter right side.
with the new No. 8 screws supplied with the kit.
(Refer to figure 2-4.)
(11) Fasten this inner member to the right
side of the voltmeter with the three No. 8 screws
(7) Remove the two No. 8 screws located
supplied. (There are three threaded holes pro-
on the left side casting near the front of the
vided on the right side of the voltmeter.)
voltmeter.
