TM
11-6625-2981-14
handle. Unscrew and take off three nuts and lock-
4-4. Lubrication.
washers 6. Lift out generator 7. Apply one drop of
Refer to figure 4-1. Crank handle 2 must be removed to
instrument oil to each end of drive shaft 8 and armature
provide access for lubrication. To unscrew the crank
shaft 9. Put the generator in place. Screw on and
handle from ratchet assembly 3, it is necessary to keep
tighten three nuts with lockwashers 6. Screw on crank
the ratchet assembly from turning. To lock the ratchet
handle 2. Replace the ohmmeter in the case. Screw in
assembly, position a blade screwdriver between post 4
the six screws holding the ohmmeter in the case.
and bearing support 5. Unscrew and take off the crank
