TM 1l-6625-2629-14&P
c. Check to see whether the equipment has been
damaged, report the damage on DD Form 6 (para
modified. (Equipment which has been modified
1-3).
--
will have the MWO number on the front panel,
b. Check the equipment against packing slip to
near the nomenclature plate. ) Check also to see
see if the shipment is complete. Report all
whether all currently applicable MWO's have
discrepancies in accordance with the instructions
been applied. (Current MWO's applicable to the
of TM 38-750. The equipment should be placed in
equipment are listed in DA Pam 310-7. )
service even though a minor assembly or part that
does not affect proper functioning is missing.
Section II. INSTALLATION INSTRUCTIONS
has sufficient ventilation and is not
2-4. Assembly and Installation
subject to excessive heat from other
a. The modulation meter is fully assembled
equipment in the rack.
when shipped. It may be used as a free-standing
(2) Mount the modulation meter using all
test equipment on a work bench or may be
eight screw-slot locations.
mounted in a standard 19-inch relay rack.
(3) Locate a power receptacle convenient to
b. To install the modualtion meter in an
the modulation meter.
equipment rack, proceed as follows:
(4) Set the modulation meter line voltage
(1) Refer to figure 2-2 and drill and tap the
selection switch to match the available power
holes for eight mounting screws.
NOTES
(5) Insert the modulation meter power plug
Most equipment racks have tapped holes
into the receptacle and perform the operator's
at regular intervals to match the slots on
checkout procedure (para 4-9).
the modulation meter front panel.
Choose an equipment rack location that
2-2
Figure 2-2, Rack mounting dimensions.
