TM 1l-6625-2629-14&P
CHAPTER 2
S E R V I C E UPON RECEIPT AND INSTALLATION
Section I. SERViCE UPON RECEIPT OF MATERIAL
2-1. Siting
The modulation meter is an item of portable (or
rack mountable) test equipment. It is not in-
tended for outdoor locations unless protected
from sun, rain, etc, or under environmental
conditions hostile to human habitation. Normal
operation can be expected with ambient tem-
peratures and humidity levels as indicated in
2-2. Unpacking
a. Packaging Data. When packed for shipment,
the modulation meter is placed in a waterproof
carton and packed in a wooden packing case. A
typical packing case and its contents are shown in
b. Removing Contents ( Wooden Packing
Case). Perform all of the procedures in (1)
through (5) below when unpacking an equipment
in a wooden packing case.
(1) Cut and fold back the metal straps.
CAUTION
Do not attempt to pry off the sides; this
may damage the equipment.
(2) Remove the nails from the cover and one
side of the wooden packing case with a nailpuller.
Remove the cover and one side.
(3) Open the moistureproof barrier that
covers the outer corrugated carton. Remove the
carton.
Figure 2-1. Typical packaging.
(4) Open the outer corrugated carton and the
moisture-vaporproof barrier within the carton.
2-3. Checking Unpacked Equipment
Remove the inner corrugated carton.
a. Inspect the equipment for damage incurred
(5) Open the inner corrugated carton and
during shipment. If the equipment has been
remove the instrument.
2-1
