TM 9-6625-1754-14
put the negative end down into position
Fuse
and slide the battery into place.
a.. Replacement of Batteries.
(1) To remove 1.5 volt D cell, pull straight
a. Take out the batteries and the 10-ampere
out .
fuse, then unsolder then black and red leads from
(2) To replace 1.5 volt D cell, place positive
terminals.
terminal (centerpost) on spring contact.
b. Grip the strain relief clamp at front panel
Push contact in and slip negative side of
surface with Heyco pliers or needle-nose pliers,
D cell in.
compress the two parts, and pull the clamp out.
Replacement of 10-Ampere Fuse.
c. To replace the test leads, place both lends
(1) To remove 10-ampere fuse, first remove
D cell, then pull fuse straight out.
t h r o u g h the Heyco clamp leaving about 1 1/4
(2) To replace fuse, push fuse straight in.
i n c h e s . Close the clam and push through the
hole from the front. Solder the red lend to the loft
(3) To remove 6.75 volt mercury buttery,
terminal and the black lead to the right terminal.
remove D cell and lift up from center of
Replace the batteries and the 10-ampere fuse as
battery.
( 4 ) To replace 6.75 volt mercury battery,
outlined in paragraph 23.
