CHAPTER 3
ORGANIZATIONAL MAINTENANCE INSTRUCTIONS
Section I. SPECIAL TOOLS AND EQUIPMENT
25.
ORGANIZATIONAL MAINTENANCE REPAIR
24. SPECIAL TOOLS AND EQUIPMENT
PARTS
No special tools or equipment are needed by the
operator or organizational maintenance personnel for
Organizational maintenance repair parts are
maintaining the starter torque tester.
listed in Appendix III of this manual.
Section II. LUBRICATION
requires saturation with medium machine oil, Federal
26. GENERAL LUBRICATION INFORMATION
Specification VV-0-526 (fig. 14). A few drops of
lubricating oil, Military Specification MIL-0-11773,
The entire starter torque tester is so constructed
should be applied occasionally at the point where the
that only a minimum amount of lubrication is required.
pushrod enters the torquemeter.
Occasionally apply a light coat of grease, Military
27. DETAILED LUBRICATION INFORMATION
Specification MIL-G-7711, to flexible drive shaft (18, fig.
An oil wick, in each of the cam shafts, supplies all
bearing surfaces with sufficient lubrication and simply
14
