TM 11-6625-539-15-2
INSTALLATION
2-2. Checking U n p a c k e d E q u i p m e n t
2-1. Unpacking
a. Inspect the equipment for damage incurred dur-
a. Packaging Data. When packed for shipment,
ing shipment.
Test Set, Transistor TS-1836B/U is placed in a
b. Check to see that the equipment is complete. The
waterproof carton and packed in a wooden packing
equipment is normally shipped less the batteries. Re-
case. A typical packing case and its contents are
port all discrepancies in accordance with TM 38-750.
shown in figure 2-1.
Shortage of a minor assembly or part that does not
b. Removing Contents (Wooden Packing Case).
affect proper functioning of the equipment should
Perform all the procedures in (1) through (5) below
not prevent use of the equipment.
when unpacking equipment packed in a wooden pack-
c. If the equipment has been used or reconditioned,
ing case (fig. 2-1).
see whether it has been changed by a modification
(1) Cut and fold back the metal straps.
work order (MWO). If the equipment has been modi-
fied, the MWO number will appear on the side near
the nomenclature plate. Check to see whether the
Caution: Do not attempt to pry off the
MWO number (if any) and appropriate notations
sides; this may damage the equipment.
concerning the modification have been entered in the
equipment manual.
(2) Remove the nails from the cover and one side
N o t e . Current
MWO's
applicable
to
the
equipment
are
listed
in DA Pam 310-7.
of the wooden packing case with a nailpuller. Re-
move the cover and one side.
2 - 3 . Cable Connections
(3) Open the moistureproof barrier that covers
No cable connections are necessary for operation of
the outer corrugated carton. Remove the carton.
the test set other than the three accessory test leads.
(4) Open the outer corrugated carton and the
Connect the three accessory test leads as follows:
moisture-vaporproof barrier within the carton. Re-
a. Insert the red plug into the red jack.
move the inner corrugated carton.
b. Insert the black plug into the black jack.
(5) Open the inner corrugated carton, and re-
c. Insert the yellow plug into the yellow jack.
move the instrument.
