TM6625-316-35-14
Figure 14. Panel of Test Set, Electron Tube TV-2(*)/U, location of parts.
ing bolts on the bottom of each mounting bracket
20. Lowering Chassis
just behind the cutouts on the resistor mounting
board (fig. 16).
If the part to be checked or replaced is located
b. Raise the tube tester to a vertical position
on the front of the tube tester chassis or mounted
so that it rests on the bottom edge of the panel
through the chassis, lower the chassis so that
and the chassis supports. Remove the mounting
the part can be reached without removing the
bolts nearer the top of the chassis on both
chassis from its mounting brackets; proceed as
follows :
a. Place the panel of the tube tester face
Note. On the TV2A/U only, remove the flathead
downward (fig. 15). Remove the chassis mount-
bolt on the rear of the chassis (fig. 18).
AGO 1428A
25
