TM 11-6625-291-20P
SECTION
I
INTRODUCTION
1. Scope
This manual lists spares and repair parts;
b. Source, Maintenance, and Recoverability
special tools; special test, measurement, and
(SMR) Codes.
diagnostic equipment (TMDE), and other special
support equipment required for performance of
(1) Source code. Source codes indicate the
o r g a n i z a t i o n a l support maintenance of the
manner of acquiring support items for
TS-585A/U, TS-585B/U, TS-585C/U and TS-585D/U.
maintenance, repair, or overhaul of end items.
It authorizes requisitioning and issue of spares
Source codes are entered in the first and second
and repair parts as indicated by the source and
positions of the Uniform SMR Code format as
maintenance codes.
follows:
2. General
Code
Definition
This Repair Parts and Special Tools List is divided
into the following sections:
PA -Item procured and stocked for antici-
pated or known usage.
a. Section II. Repair Parts List. A list of spares
and repair parts authorized for use in the per-
NOTE
formance of maintenance. The list also includes
parts which must be removed for replacement of
the authorized parts. Parts lists are composed of
functional groups in numeric sequence, with the
C a n n i b a l i z a t i o n or salvage may be
used as a source of supply for any items
parts in each group listed in figure and item
number sequence.
source coded above except those
coded XA and aircraft support items
b. Section III. Special Tools List. N o t
as restricted by AR 750-1.
applicable.
(2) Maintenance code. Maintenance codes
are assigned to indicate the levels of maintenance
c. Section IV. National Stock Number and Part
Number Index. A list, in National item identifica-
authorized to USE and REPAIR support items. The
tion number (NIIN) sequence, of all National stock
maintenance codes are entered in the third and
fourth positions of the Uniform SMR Code format
numbers (NSN) appearing in the listings, followed
by a list, in alphameric sequence, of all part
as follows:
numbers appearing in the listings. National stock
numbers and part numbers are cross-referenced
(a) The maintenance code entered in the
third position will indicate the lowest
t o each illustration figure and item number
maintenance level authorized to remove, replace,
appearance.
and use the support item. The maintenance code
3. Explanation of Columns
entered in the third position will indicate one of
the following levels of maintenance:
a. Illustration. This column is divided as
ApplicationlExplanation
follows:
Code
(1) F i g u r e n u m b e r . Indicates the figure
O- Support item is removed, replaced,
number of the illustration on which the item is
used at the organizational level.
shown.
(b) The maintenance code entered in the
fourth position indicates whether the item is to be
(2) Item number. The number used to iden-
repaired and identifies the lowest maintenance
tify item called out in the illustration.
