TM 11-6625-291-14/TO 33A1-7-23-1
4-15. REPLACEMENT OF RUBBER BUMPERS ON OUTPUT METER TS-585A/U, TS-585B/U, TS-585C/U
AND TS-565D/U.
This procedure shows typical replacement of rubber bumpers. Shown below is a replacement pro-
cedure for a rubber bumper on Output Meter TS-585A/U. This procedure is the same for Output Meters
TS-585B/U, TS-585C/U, and TS-585D/U.
This task covers:
1. Removal
2. Installation
INITIAL SETUP
Personnel Required
Tools
One operator
Tool Kit, Electronic Equipment
TK-105/G
Equipment Condition
Materials/Parts
Output meter on workbench
Bumper, rubber
NSN 5340-00-550-8485
ACTION
REMARKS
ITEM
LOCATION
REMOVAL
NOTE
Remove and replace only those bumpers that need to be
replaced.
Using flat-tip screwdriver, remove screw in
Rubber bumper (1)
Output Meter
center of rubber bumper. Remove rubber
and screw (2)
TS-585A/U
bumper.
Throw away broken bumper.
INSTALLATION
Put new rubber bumper in place. Using
Rubber bumper (1)
Output Meter
flat-tip screwdriver, install screw.
and screw (2)
TS-585A/U
4-16
