TM 9-6695-248-34P
h.
Quantity Incorporated in Unit. Indicates the quantity of the item used breakout shown on the illustration
figure, which is prepared for a functional group, sub functional group, or an assembly. A "V" appearing in this column in
lieu of quantity is applicable (e.g., shims, spacers, etc)
4.
Special Information.
a.
Repair parts for components of standards sets which can be identified as existing in the supply system will
be requisitioned through normal supply channels from the appropriate supply commodity manager,
b.
Repair parts for components of standards sets which cannot be identified as to proper supply source will
be requ8istionedfrom USAMICOM, using routing identifier B64 and furnishing as a minimum, the following as exception
data.
(1)
Component stock number of the individual end item to be repaired.
(2)
Component manufacturer's equipment model number and serial number.
(3)
The equipment manufacturer's stock number as listed in the appropriate manual for the desired repair
part.
(4)
The repair part reference designation, circuit reference, circuit symbol schematic designation, or reference
number as listed in the manufacturer's manual.
(5)
The technical specification of t he repair part as contained in the appropriate manufacturer's manual.
(6)
The title and date of the manufacturer's manual from which the information in paragraphs a, b(3), (4), and
(5) above was taken.
NOTE
Repair parts should not be requisitioned for plug-in boards identified in the plug-in board exchange program, except by the
depot designated to perform the repair. Repair of calibration set components, with plug-in board assemblies or
subassemblies designated as program exchange replacements with a recoverability code of L, will be accomplished by
replacing the plug-in-board.
c.
The plug-in board exchange program functions are as follows:
(1)
Requisitioning instructions for initial issue plug-in boards will be provided since new instrument
boards are included in t
(2)
As a plug-in board covered by the program fails, a replacement will be requisitioned. Requisitions
will be submitted to Commander, US Army Missile Command, B64, Redstone Arsenal, AL 35809
(3)
Simultaneously with c(2) above, the defective board being replaced will be shipped by certified
mail, return receipt requested, to the following address:
Transportation Officer
Anniston Army Depot
M/F Field Service Stock
Anniston, AL 36201
When requisitioning a replacement board, the turn-in document number of the replaced board shall be cited on the
requisition.
5. How to Locate Repairs Parts
a.
When NSN or reference number is unknown:
(1)
First.
Using the table of contents, determine the assembly (functional group) within which the
repair part belongs.
5
