SECTION I
INTRODUCTION
1. GENERAL
a. AMC Materiel Codes. Not applicable.
This appendix lists the repair parts and
maintenance supplies authorized and required for
b. Source Codes. Source codes are shown in this
organizational thru depot maintenance of the Tester,
column as assigned to items by U.S. Army Aviation
Starter Torque, Part No.
RT320-200, FSN 4920-
Materiel Command. The code symbols indicate the
7394584.
This is the authority to requisition.
It
selection status and source of supply for each repair
supplements tables of equipment and allowance and
part as defined hereafter:
other applicable authorization documents.
The
Code P1 applies to repair parts which are low mortality
quantities of repair parts and special tools required to be
parts; procured by commodity command, stocked only
on hand or on order at all times for performance of
in and supplied from commodity command key depots,
operator/crew organizational maintenance in units
and authorized for installation at in dictated
and/or organizations constitute a prescribed load which
maintenance echelons.
will be maintained in accordance with AR 735-35.
c. Maintenance Level Code. The
code symbol
2. ARRANGEMENT
used in the maintenance level column
indicates the
lowest maintenance echelon authorized
to install the
This appendix consists of four sections, as
repair parts.
Capabilities of higher
echelons are
follows:
considered equal or better.
a. 1, Introduction.
(1) Code O -- Organizational Maintenance
Category.
b. 2, Illustrated Parts List. All repair parts are
(2) Code F -- Direct Support Maintenance
listed in disassembly order and indented when required
Category.
to indicate relationship t,. the next higher assembly.
(3) Code H -- General Support Maintenance
Items appearing more than once in an assembly will be
Category.
repeated to show relation to the illustration. Illustrations
(4) Code D -- Depot Maintenance Category.
appear in the maintenance portion of this manual.
d. Recoverability Code.
Recoverability codes
reflect the recoverability or reparability characteristics of
repair parts upon removal from equipments at time of
maintenance, repair, or overhaul.
d.
4,
Cross-Reference Indices.
This
section is divided into two as follows:
(1) Code R applies to repair parts and
assemblies which are economically
reparable at direct and general support
(1)
I, the alpha-numerical part
maintenance activities and are normally
number index, contains a listing of all part
furnished by supply on an exchange
numbers appearing in the text pages of
basis.
this manual. Cross-reference is made to
figure and index number, Federal stock
number, Federal supply code for
(2) Repair parts and assemblies not assigned
manufacturer, and page number in order.
a recoverability code shall be considered
"throwaway" items.
(2)
II, Federal stock number cross-
reference index, is arranged in numerical
e. Federal Stock Number. The Federal stock
order by stock number. Cross-reference
number consists of the applicable 4-digit FSC code
is made to figure and index number, part
number plus the 7-digit Federal item identification
number, Federal supply code for
number which are to be utilized for requisitioning,
manufacturer, and page number in order.
storage, and accountability purposes. Items without
3. EXPLANATION OF COLUMNS
31
