TM 11-6625-444-14-1
Section Il. INSTALLATION INSTRUCTIONS
2-3. Rack Installation
the rear panel to 115 (if line power is 115V AC) or
230 (if line power is 230V AC).
(3) Connect line power cord to input power
installation in a standard 19-inch wide equipment
connector on rear panel and then plug it into the
rack. Attachment to the equipment rack is
nearest line power receptacle.
facilitated directly through holes in the front
CAUTION
panel of the voltmeter.
Insure that the round pin on the line
b. Procedure.
power cord is always connected to a high
(1) Position the voltmeter in the equipment
quality earth ground.
rack and attach in place in accordance with figure
(4) Make the appropriate connections at the
rear panel as shown in figure 2-3. The voltage
(2) Set the slide switch (16, fig. 3-2
) on
