TM 11-6625-366-24P
INTRODUCTION
NOTE
1. Scope
cannibalization or salvage may be used as a
This manual lists repair parts ant] Special tools
source of supply for any items source coded
required for performance of organizational, direct
above except those coded X4, XD, and
support. and general support maintenance of the TS -
aircraft support items as restricted by AR
352B/U.
700-42.
2. General
(2) Maintenance code. Maintenance codes are
This Repair Parts and Special Took List is divided
assigned to indicate the levels of maintenance
into the following sections:
authorized to (USF, and REPAIR support items. The
maintenance codes are entered in the third and fourth
parts authorized for use in the performance of
positions of the (Uniforrn SMR Code format as
maintenance. The list also includes parts which must
follows:
be removed for replacement of the authorized parts.
(a) The maintenance code entered in the third
Parts lists are composed of functional groups in
position will indicate the lowest maintenance level
ascending numerical sequence, with the parts in each
authorized to remove, replace, and use the support
group listed in figure and item number sequence.
item. The maintenance code entered in the third
b. Section III. Special Tools List. Not applicable.
position will indicate one of the following levels of
maintenance:
Number Index. A list, in ascending National item
Code
Application/Explanation
identification number (NIIN, last 9 digits) sequence,
O Support item is removed, replaced, used at the
of all National stock numbers appearing in the
organizational level.
listings, followed by a list, in alphameric sequence, of
H - Support item is removed, replaced. used at the
all part numbers appearing in the listings. National
general support level.
stock number and part numbers are cross-referenced
(b) The maintenance code entered in the
to each illustration figure and item number ap-
fourth position indicates whether the item is to be
pearance.
repaired and identifies the lowest maintenance level
3. Explanation of Columns
with the capability to perform complete repair (i. e.,
The following provides an explanation of columns
all authorized maintenance functions). This position
found in the tabular listings:
will contain one of the following maintenance codes:
a. Illustration This column is divided as follows:
Code
Applacation/Explination
(1) Figure number. Indicates the figure number
H -The lowest maintenance level capable of complete
of the illustration in which the item is shown.
repair of the support item is the general
(2) Item number. The number used to identify
support level.
each item called out in the illustration.
Z Nonreparable. No repair is authorized.
b. Source, Maintenance. and Recoverability Codes
(3) Recoverability code. Recoverability y codes
(SMR).
are assigned to support items to indicate the
(1) Source code. Source codes are assigned to
disposition action on unserviceable items. The
support items to indicate the manner of acquiring
recoverability code is entered in the fifth position of
support items for maintenance, repair, or overhaul of
the Uniform SMR Code format as follows:
end items. Source codes are entered in the first and
Recoverability
second positions of the Uniform SMR Code format as
Definition
codes
follows:
Z Nonreparable item. When unserviceable, con-
Code
Definition
demn and dispose at the level indicated in
PA - Item procured and stocked for anticipated or
position 3.
known usage.
H Reparable item. When uneconomically reparable,
XD A support item that is not stocked. When
condemn and dispose at the general support
required, item will be procured through
level.
normal supply channels.
