TM
11-6625-291-14/TO
33A1-7-23-1
6-11. MAINTENANCE OF RADIAL RESISTOR.
This task covers:
1. Test
2. Removal
3. Installation
INITIAL SETUP
Tools
Equipment Condition
Output meter on workbench
Tool Kit, Electronic Equipment
TK-105/G
Test Equipment
Materials/Parts
Capacitance-Inductance-
Resistor, fixed, wire wound
Resistance Test Set
Nut, hex
AN/URM-90
See TM 11-6625-291-24P
Personnel Required
One technician
ACTION
REMARKS
ITEM
LOCATION
NOTE
See paragraph 6-7 for removal of chassis from case.
TEST
WARNING
Soldering iron is hot. Severe burns to personnel can result
from improper handling.
Terminal leads (1)
1. Radial resistor
wires.
2. Radial resistor
Using test set, test radial resistor.
Test set (2)
Replace radial resistor if bad.
REMOVAL
Using 5/16-inch wrench, remove hex nut. Lift
Terminal board
Hex nut (3), flat
off radial resistor.
AT1
washer (4), radial
Throw away old radial resistor.
resistor (5), flat
washer (6) and
screw (7)
6-16
