TM-11-6625-2784-24P
INTRODUCTION
1. Scope
AD--Item to be assembled at depot maintenance level.
XD--A support item that is not stocked. When re-
This manual lists spares and repair parts; special tools;
quired, item will be procured through normal supply
special test, measurement, and diagnostic equipment
channels.
(TMDE), and other special support equipment required
NOTE
for performance of organizational, direct support, and
general support maintenance of the TS-3565/TRS-2. It
Cannibalization or salvage may be used as a
authorizes the requisitioning and issue of spares and
source of supply for any items source coded
repair parts as indicated by the source and maintenance
above except those coded XA and aircraft sup-
codes.
port items as restricted by AR 700-42.
(2) Maintenance code. Maintenance codes are
2. General
assigned to indicate the levels of maintenance authoriz-
This Repair Parts and Special Tools List is divided into
ed to USE and REPAIR support items. The mainte-
the following sections:
nance codes are entered in the third and fourth positions
of the Uniform SMR Code format as follows:
and repair parts authorized for use in the performance
(a) The maintenance code entered in the third
of maintenance. The list also includes parts which must
position will indicate the lowest maintenance level
be removed for replacement of the authorized parts.
authorized to remove, replace, and use the support
Parts lists are composed of functional groups in
item. The maintenance code entered in the third posi-
numeric sequence, with the parts in each group listed in
tion will indicate one of the following levels of
figure and item number sequence.
maintenance:
b. Section III. Special Tools List. Not applicable.
Code
Application/Explanation
c. Section IV. National Stock Number and Part
F--Support item is removed, replaced, used at the direct
Number Index. A list, in National item identification
support level.
number (NIIN) sequence, of all National stock numbers
D--Support items that are removed, replaced, used at
(NW) appearing in the listings, followed by a list, in
the depot, mobile depot, specialized repair activity
alphameric sequence, of all part numbers appearing in
only.
the listing. National stock numbers and part numbers
(b) The maintenance code entered in the fourth
are cross-referenced to each illustration figure and item
position indicates whether the item is to be repaired and
number appearance.
identifies the lowest maintenance level with the capabili-
ty to perform complete repair (i.e., all authorized
3. Explanation of Columns
maintenance functions). This position will contain one
a. Illustration. This column is divided as follows:
of the following maintenance codes:
(1) Figure number. Indicates the figure number
Code
Application/Explanation
of the illustration on which the item is shown.
(2) Item number. The number used to identify
F--The lowest maintenance level capable of complete
item called out in the illustration.
repair of the support item is the direct support level.
D--The lowest maintenance level capable of complete
b. Source, Maintenance, and Recoverability (SMR)
repair of the support item is the depot level.
Codes.
Z--Nonreparable. No repair is authorized.
(1) Source code. Source codes indicate the man-
(3) Recoverability code. Recoverability codes
ner of acquiring support items for maintenance, repair,
are assigned to support items to indicate the disposition
or overhaul of end items. Source codes are entered in
action on unserviceable items. The recoverability code is
the first and second positions of the Uniform SMR
entered in the fifth position of the Uniform SMR Code
Code format as follows:
format as follows:
Code
Definition
Recoverability
PA--Item procured and stocked for anticipated or
codes
Defihition
known usage.
Z--Nonreparable item. When unserviceable, condemn
AF--Item to be assembled at direct support mainte-
and dispose at the level indicated in position 3.
n a n c e level.
