TM 11-6625-213-34P
INTRODUCTION
Definition
1. Scope
XD-A support item that is not stocked. When
This manual lists spares and repair parts; special
required, item will be procured through nor-
tools; special test, measurement, and diagnostic
mal supply channels.
equipment (TMDE), and other special support
NOTE
equipment required for performance of direct sup-
Cannibalization or salvage may be used
port and general support maintenance of the
as a source of supply for any items source
TS-538B/U,
TS-538/U,
TS-538A/U,
and
coded above except those coded XA and
TS-538C/U. It authorizes the requisitioning and
aircraft support items as restricted by
issue of spares and repair parts as indicated by the
AR 700-42.
source and maintenance codes.
(2) Maintenance code. Maintenance codes are
2. General
assigned to indicate the levels of maintenance
This Repair Parts and Special Tools List is divided
authorized to USE and REPAIR support items; The
into the following sections:
maintenance codes are entered in the third and
fourth positions of the Uniform SMR Code format
and repair parts authorized for use in the per-
as follows:
formance of maintenance. The list also includes
(a) The maintenance code entered in the third
parts which must be removed for replacement of the
position will indicate the lowest maintenance level
authorized to remove, replace, and use the support
authorized parts. Parts lists are composed of func-
item. The maintenance code entered in the third
tional groups in numeric sequence, with the parts in
each group listed in figure and item number sequen-
position will indicate one of the following levels of
ce.
maintenance:
b. Section III. Special Tools List. Not a p -
Code
Application/Explanation
plicable.
O-Support item is removed, replaced, used at the
c. Section IV. National Stock Number and Part
organizational level.
Number Index. A list, in National item iden-
F-Support item is removed, replaced, used at the
tification number (NIIN) sequence, of all National
direct support level.
stock numbers (NSN) appearing in the listings,
H-Support item is removed, replaced, used at the
followed by a list, in alphameric sequence, of all part
general support level.
numbers appearing in the listings. National stock
(b) The maintenance code entered in the
numbers and parts numbers are cross-referenced to
fourth position indicates whether the item is to be
each illustration figure and item number ap-
repaired and identifies the lowest maintenance level
pearance.
with the capability to perform complete repair (i.e.,
all authorized maintenance functions). This position
3. Explanation of Columns
will contain one of the following maintenance codes:
a. Illustration. This column is divided as follows:
Code
Application/Explanation
(1) Figure number. Indicates the figure number
F-The lowest maintenance level capable of com-
of the illustration on which the item is shown.
plete repair of the support item is the direct
(2) Item number. The number used to identify
support level.
item called out in the illustration.
Z-Nonreparable. No repair is authorized.
b. Source, Maintenance, and Recoverability
(3) Recoverability code. Recoverability codes
(SMR) Codes.
are assigned to support items to indicate the
(1) source code. Source codes indicate the man-
disposition action on unserviceable items. The
ner of acquiring support items for maintenance,
recoverability code is entered in the fifth position of
repair, or overhaul of end items. Source codes are en-
the Uniform SMR Code format as follows:
tered in the first and second positions of the
Recoverability
Uniform SMR Code format as follows:
codes
Definition
Definition
Code
Z-Nonreparable item. When unserviceable, con-
PA-Item procured and stocked for anticipated or
demn and dispose at the level indicated in
known usage.
position 3.
