1-5. Location of Repair Parts
measure is expressed by a two-character alpha-
betical abbreviation; e.g., ea, in, pr, etc., and is the
a. This manual contains one cross-reference in-
basis used to indicate quantities and allowances in
dex (see V) to be used to locate a repair part when
subsequent columns. When the unit of measure dif-
either the Federal stock number or reference num-
fers from the unit of issue, the lowest unit of issue
ber (manufacturer's part number) is known. The
that will satisfy the required units of measure will
first column in the index is prepared in numerical
be requisitioned.
or alphanumeric sequence in ascending order. The
e. Quantity Incorporated in Unit. This column in-
reference numbers (manufacturer's part numbers)
dicates the quantity of the item used in the equip-
are listed immediately following the last listed Fed-
ment.
eral stock number in the index of Federal stock num-
f. 15-Day Organizational Maintenance Al1owance.
.
bers.
(1) The repair parts indicated by an asterisk
b. When the Federal stock number or reference
in the allowance column represent those authorized
number is known, follow the procedures given in (1)
for use at the organizational category, and will be re-
and (2) below.
quisitioned on an "as required" basis, until stockage
is based on demand in accordance with AR 710-2.
(1) Refer to the index of Federal stock numbers
(see V) and locate the Federal stock number or ref-
(2) Major Army commanders are authorized to
erence number. The FSN and reference number are
approve reduction in the range of support items auth-
cross-referenced to the applicable figure and item
orized for use in units within their commands. Rec-
number or reference designation.
ommendations for increase in range of items autho-
rized for use will be forwarded to Commander, US
(2) Refer to the repair parts list (see III) and lo-
cate the figure number (col 7a) and item number or
Army Electronics Command, ATTN: AMSEL-MA-
reference designation (col 7b) as noted in the FSN
CRA, Fort Monmouth, N.J., 07703. Any changes ap-
index.
proved will be reflected in a revision to the RPSTL.
c. When the figure and item number or reference
(3) Allowance quantities are indicated in the spe-
designation are known, scrutinize columns 7a and 7b
cial tools list section for spcecial tools, TMDE, and
of the repair parts list (see III) until the item is lo-
other equipment.
cated.
g. Illustration. This column is divided as follows:
d. When the FSN, reference number, figure num-
(1) Figure number. Indicates the figure number
ber, item number and reference designation are not
of the illustration on which the item is shown in
known, scrutinize column 3 of the repair parts list
TM 11-6625-539-15.
(2) Item number. Indicates the item number or
(see III), which is arranged in alphabetical order.
reference designation used to reference the item
in the illustration.
1-6. Abbreviations
1-4. Special Information
Not applicable.
a. Usable on codes are included in column 3. Un-
1-7. Reporting of Equipment
coded items are applicable to all models. Identifica-
tion of the usable on codes used in this publication
Publication Improvements
are--
The reporting of errors, omissions, and recommenda-
Code
Used on
tions for improving this publication by the indivi-
TS-1836/U
AM7
dual user is encouraged. Reports should be submitted
b. The following publication pertains to the TS-
on DA Form 2028 (Recommended Changes to Pub-
1836/U and its components:
lications) and forwarded direct to Commander, US
TM 11-6625-539-15 Operator, Organizational, Field
Army Electronics Command, ATTN: AMSEL-MA-
and Depot Maintenance Ma-
CRA, Fort Monmouth, N.J., 07703.
nual: Transistor Test Set TS-
1836/U.
(Next printed page is 6.)
4
