TM 11-6625-539-15-2
function.
maintenance function vary at different maintenance
categories, appropriate "worktime" figures will be
shown for each category. The number of task-hours
C-4. Tool and Test Equipment Requirements
specified by the "worktime" figure represents the
(Table 1)
average time required to restore an item (assembly,
a. Tool or Test Equipment Reference Code. The
subassembly, component, module, end item or
numbers in this column coincide with the numbers
system) to a serviceable condition under typical field
used in the tools and equipment column of the MAC.
operating conditions. This time includes preparation
The numbers indicate the applicable tool or test
time, troubleshooting time and quality assurance
equipment for the maintenance functions.
quality control time in addition to the time required
b. Maintenance Category. The codes in this column
to perform the specific tasks identified for the
indicate the maintenance category allocated the tool
maintenance functions authorized in the mainte-
or test equipment.
nance allocation chart. Subcolumns of column 4 are
c. Nomenclature. This column lists the noun name
as follows:
and nomenclature of the tools and test equipment
C - Operator/crew
required to perform the maintenance functions.
O - Organizational
F - Direct support
d. National/NATO Stock Number. This column
lists the National/NATO stock number of the specific
H - General support
D - Depot
tool or test equipment.
e. Column 5, Tools and Equipment. Column 5
e. Tool Number. This column lists the manufac-
turer's part number of the tool followed by the
specifies by code, those common tool sets (not
individual tools) and special tools, test, and support
Federal Supply Code for Manufacturers (5-digit) in
equipment required to perform the designated
parentheses.
Change 3
C-2
