quantity of the item used in the breakout shown
on the illustration figure, which is prepared for a
reparable, condemn and dispose at the
functional group, subfunctional group, or an
general support level.
D Reparable item. When beyond lower level
4. Special Information
repair capability, return to depot. Con-
The following publication pertains to the
demnation and disposal not authorized
AN/URM-145 and its components:
below depot level.
c. National Stock Number. Indicates the
National stock number assigned to the item and
will be used for requisitioning purposes.
5. How to Locate Repair Parts
d. Part Number. Indicate the primary number
a. When National stock number or part number
used by the manufacturer (individual, company,
firm, corporation, or Government activity), which
(1) First. U s i n g t h e table of contents,
controls the design and characteristics of the item
determine the functional group within which the
by means of its engineering drawings,
item belongs. This is necessary since illustrations
are prepared for functional groups and listings are
requirements to identify an item or range of items.
divided into the same groups.
(2) Second. Find the illustration covering the
When a stock numbered item is
functional group to which the item belongs.
requisitioned, the repair part received may
(3) Third. Identify the item on the illustration
have a different part number than the part
and note the illustration figure and item number of
e. Federal Supply Code for Manufacturer
(4) Fourth. Using the Repair Parts Listing,
(FSCM). The FSCM is a 5-digit numeric code
find the figure and item number noted on the
listed in SB 708-42 which is used to identify the
manufacturer, distributor, or Government agency,
b. When National stock number or part number
f. Description. Indicates the Federal item name
(1) First. Using the Index of National Stock
and, if required, a minimum description to identify
Numbers and Part Numbers, find the pertinent
National stock number or part number. This index
g. Unit of Measure (U/M). Indicates
is in NIIN sequence followed by a list of part
standard of the basic quantity of the listed item as
numbers in alphameric sequence, cross-referenced
used in performing the actual maintenance func-
to the illustration figure number and item number.
t i o n . This measure is expressed by a two
(2) Second. After finding the figure and item
character alphabetical abbreviation (e.g., ea, in,
number, locate the figure and item number in the
pr, etc). When the unit of measure differs from the
repair parts list.
unit of issue, the lowest unit of issue that will
satisfy the required units of measure will be
h. Quantity Incorporated in Unit. Indicates the
(Next printed page is 5/(6 blank) )