TM 11-6625-320-24P
SECTION I
INTRODUCTION
1. Scope
Code
Definition
PA Item procured and stacked for anticipated or
This manual lists spares and repair parts; special
known usage.
tools; special test, measurement, and diagnostic
XDA support item that is not stocked. When
equipment (TMDE), and other special support
will
be
procured
item
required,
required for performance of
equipment
through normal supply channels.
organizational, direct support, and general support
NOTE
m a i n t e n a n c e of the ME-30A/U, ME-30B/U,
Cannibalization or salvage may be used as
M E - 3 0 C / U and ME-30E/U. It authorizes the
a source of supply for any items source
requisitioning and issue of spares and repair parts
coded above except those coded XA and
as indicated by the source and maintenance codes.
aircraft support items as restricted by AR
2. General
700-42.
This Repair Parts and Special Tools List is divided
(2) Maintenance code. Maintenance codes are
into the following Sections:
assigned to indicate the levels of maintenance
a Section II--Repair Parts List. A list of
authorized to USE and REPAIR support items.
spares and repair parts authorized for use in the
The maintenance codes are entered in the third and
performance of maintenance. The list also includes
fourth positions of the Uniform SMR Code format
parts which must be removed l for replacement of
as follows:
the authorized parts. Parts lists are composed of
(a) The maintenance code entered in the
functional groups in numeric sequence, with the
third position will indicate the lowest maintenance
parts in each group listed in figure and item
level authorized to remove, replace, and use the
number sequence.
support item. The maintenance code entered in the
b. Section IIISpecial Tools List. Not ap-
third position will indicate one of the following
plicable.
levels of maintenance:
c. Section IV--National Stock Number and Part
Application/Explanation
Code
N u m b e r Index. A list, in National item iden-
OSupport item is removed, replaced, used at
tification number (NIIN) sequence, of all National
the organizational level.
stock numbers (NSN) appearing in the listings,
HSupport item is removed, replaced, used at
followed by a list, in alphameric sequence, of all
the general support level.
part numbers appearing in the listings. National
(b) The maintenance code entered in the
and part numbers are
stock numbers
fourth position indicates whether the item is to be
cross-referenced to each illustration figure and
repaired and identifies the lowest maintenance level
item number appearance.
with the capability to perform complete repair (i.e.,
a l l authorized - m a i n t e n a n c e f i c t i o n s ) . This
3. Explanation of Columns
position will contain one of the following main-
a. Illustration. This column is divided as
tenance codes:
follows:
(1) Figure number. Indicates the f i g u r e
Code
Application/Explanation
number of the illustration on which the item is
ZNonreparable No repair is authorized.
shown.
(3) Recoverability code. Recoverability Codes
(2) I t e m n u m b e r . T h e n u m b e r u s e d t o
are assigned to support items to indicate the
identify item called out in the illustration.
disposition action on unserviceable items. The
b. Source, Maintenance, and Recoverability
recoverability code is entered in the fifth position
(SMR) Codes.
of the Uniform SMR Code format as follows:
(1) Source code. Source codes indicate the
Recoverability
manner of acquiring support items for main-
Definition
codes
item. W h e n unserviceable,
ZNonreparable
tenance, repair, or overhaul of end items. Source
condemn and dispose at the level indicated
codes are entered in the first and second positions
in position 3.
of the Uniform SMR Code format as follows:
1
