TM 11-6625-314-20P
alphabetical abbreviation; e.g., ea, in, pr, etc., and is the
TM 11-6625-314-15 Operator, Organizational, Field and
basis used to indicate quantities and allowances in
Depot Maintenance Manual: Multimeter ANUSM-33.
subsequent columns. When the unit of measure differs
from the unit of issue, the lowest unit of issue that will
1-5. Location of Repair Parts
satisfy the required units of measure will be
requisitioned.
a. This manual contains one cross-referenced index
e.
Quantity Incorporated in Unit This column
indicates the quantity of the item used in the equipment.
Federal
stock
number
or
reference
number
f. 15-Day Organizational Maintenance Allowance.
(manufacturer's pa number) is known. The first column
(1) The repair parts indicated by an asterisk in
in the index is prepared in numerical or alphanumeric
the allowance column represent those authorized for use
sequence in ascending order. The reference numbers
at the organizational category, and will be requisitioned
(manufacturer's part numbers) are listed immediately
on an "as required" basis, until stockage is based on
following the la listed Federal stock number in the index
demand in accordance with AR 710-2.
of Federal stock numbers.
(2) Major Army commanders are authorized to
b. When the Federal stock number or reference
approve reduction
in the range of support items
number is known, follow the procedures given in
authorized for use in units within their commands.
(1) and (2) below.
Recommendations
r increase in range of items
(1) Refer to the index of Federal stock numbers
authorized for use will be forwarded to Commander, US
Army Electronics Command, ATN: AMSEL-MA-CRA,
reference number. The FSN and reference number are
Fort Monmouth, NJ, 07703. Any changes approved will
cross-referenced to the applicable figure and item
be reflected in a revision to the RP-STL.
number or reference designation.
(3) Allowance quantities are indicated in the
(2) Refer to the repair parts list (sec III) and to
special tools list section for special tools, TMDE, and
locate the figure number (col. 7a) and item number or
other equipment.
reference designation (col. 7b) as noted in the FSN
g. Illustration This column is divided as follows:
index.
(1) Figure number. Indicates the figure number
c. When the figure and item number or reference
of the illustration on which the item is shown in TM 11-
designation are known, scrutinize columns 7a and 7b of
6625-314-15.
the repair parts list (sec III) until the item is located.
(2) Item number. Indicates the item number or
d. hen the FSN, reference number, figure number,
reference designation used to reference the item in the
item number and reference designation are not known,
illustration.
scrutinize column 3 of the repair parts list (sec III), which
is arranged in alphabetical order.
1-4. Special Information
a. Usable on codes are included in column 3.
1-6. Abbreviations
Uncoded items are applicable to all models.
Not applicable.
Identification of the usable on codes used in this
publication are-
1-7. Reporting of Equipment Publication
Improvements
Code
Used on
The
reporting
of
errors,
omissions,
and
AMD
ANIJUSM-33
recommendations for improving this publication by the
AME
AN/SM-33A
individual user is encouraged.
Reports should be
submitted on DA Form 2028 (Recommended Changes
b. The following publication pertain to the equipment
to Publications) and forwarded direct to Commander,
and its components:
US Army Electronic Command, ATTN: AMSEL-MA-
CRA, Fort Monmouth, NJ, 07703.
(Next printed page is 6)
4
