TM 11-6625-2629-14&P
H General Support
c. Column 3, Maintenance Functions. Column 3
DDepot
lists the functions to be performed on the item
e. Column 6, Tools and' Equipment. Column 6
listed in column 2.
d. Column 4, Maintenance Category. Column 4
specifies by code, those common tool sets (not
specifies, by the listing of a "worktime" figure in
individual tools) and special tools, test, and
support equipment required to perform the
the appropriate subcolumn (s), the lowest level of
maintenance authorized to perform the function
designated function.
listed in column 3. This figure represents the
C-4. Tool and Test Equipment Reqwuirements
active time required to perform that maintenance
Table 1)
function at the indicated category of main-
a. Tool or Test Equipment Reference Code. The
tenance. If the number or complexity of the tasks
numbers in this column coincide with the num-
within the listed maintenance function vary at
hers used in the tools and equipment column of
different maintenance categories, appropriate
the MAC. The numbers indicate the applicable
" worktime" figures will be shown for each
tool or test equipment for the maintenance
category. The number of man-hours specified by
functions.
the `` worktime" figure represents the average
b. Maintenance Category. The codes in this
time required to restore an item (assembly,
c o l u m n indicate the maintenance category
subassembly, component, module, end item or
allocated the tool or test equipment.
system) to a serviceable condition under typical
c. Nomenclature. This column lists the noun
field operating conditions. This time includes
name and nomenclature of the tools and test
preparation time, troubleshooting time and
equipment required to perform the maintenance
quality assurance/quality control time in ad-
functions.
ditional to the time required to perform the
d . National/NATO Stock Number. T h i s
specific tasks identified for the maintenance
column lists the National/NATO stock number of
f u n c t i o n s authorized in the maintenance
the specific tool or test equipment.
allocation chart. Subcolumns of column 4 are as
e. Tool Number. This column lists the
follows:
manufacturer's part number of the tool followed
C Operator/Crew
by the Federal Supply Code for manufacturers (5-
O Organizational
digit) in parentheses.
F Direct Support
C-2
