TM 11-6625-220-24P
SECTION I
INTRODUCTION
Code
Definition
1. Scope
XD - A support item that is not stocked. When required,
This manual lists spares and repair parts; special tools;
item will be procured through normal supply
special test, measurement, and diagnostic equipment
channels.
(TMDE), and other special support equipment required
NOTE
for performance of organizational, direct support, and
general support maintenance of the TS-488A/UP. It
Cannibalization or salvage may be used
authorizes the requisitioning and issue of spares and
as a source of supply for any items
repair parts as indicated by the source and maintenance
source coded above except those coded
codes.
XA and aircraft support items as
restricted by AR 700-42.
(2) Maintenance code. Maintenance codes are
2. General
assigned to indicate the levels of maintenance
This Repair Parts and Special Tools List is divided into
authorized to USE and REPAIR support items. The
the following sections:
maintenance codes are entered in the third and fourth
a. Section II. Repair Parts List. A list of spares
positions of the Uniform SMR Code format as follows:
and repair parts authorized for use in the performance of
(a ) The maintenance code entered in the third
maintenance. The list also includes parts which must be
position will indicate the lowest maintenance level
removed for replacement of the authorized parts. Parts
authorized to remove, replace, and use the support item.
lists are composed of functional groups in numeric
The maintenance code entered in the third position will
sequence, with the parts in each group listed in figure
indicate one of the following levels of maintenance:
and item number sequence.
Code
Application/'Explanation
b. Section III. Special Tools List. Not applicable.
O - Support item is removed, replaced, used at the
c. Section IV. National Stock Number and Part
organizational level.
Number Index. A list, in National item identification
H - Support item is removed, replaced, used at the
number (NIIN) sequence, of all National stock numbers
general support level.
(NSN) appearing in the listings, followed by a list, in
(b ) The maintenance code entered in the fourth
alphameric sequence, of all part numbers appearing in
position indicates whether the item is to be repaired and
the listings. National stock numbers and part numbers
identifies the lowest maintenance level with the capability
are cross-referenced to each illustration figure and item
to perform complete repair (i.e., all authorized
number appearance.
maintenance functions). This position will contain one of
the following maintenance codes:
3. Explanation of Columns
Code
Application/Explanation
a. Illustration. This column is divided as follows:
H - The lowest maintenance level capable of complete
(1) Figure number. Indicates the figure
repair of the support item is the general support level.
number of the illustration on which the item is shown.
Z - Nonreparable. No repair is authorized.
(2) Item number. The number used to identify
(3) Recoverability code. Recoverability codes
item called out in the illustration.
are assigned to support items to indicate the disposition
b. Source, Maintenance, and Recoverability (SMR)
action on unserviceable items. The recoverability code is
Codes.
entered in the fifth position of the Uniform SMR Code
(1) Source code. Source codes indicate the
format as follows:
manner of acquiring support items for maintenance,
Recoverability
repair, or overhaul of end items. Source codes are
codes
Definition
entered in the first and second positions of the Uniform
Z - Nonreparable item. When unserviceable, condemn
SMR Code format as follows:
and dispose at the level indicated in position 3.
Code
Definition
PA --Item procured and stocked for anticipated or known
usage.
1
